How To Use A
Finger Scrub Mitt

Get Ready

Gather all your cleaning supplies, including the Finger Scrub Mitt and Logic Interior All Purpose Cleaner, diluted at the appropriate ratio. Make sure your vehicle's interior is free from large debris or clutter — we recommend vacuuming beforehand.

Prepare the Finger Scrub Mitt

Take one Finger Scrub Mitt from the pack. Slide your fingers into the mitt, making sure it's a snug, comfortable fit. The design gives you a secure grip and precise control while cleaning.

Apply Cleaner

Spray Logic Interior All Purpose Cleaner onto the surface you're cleaning. A few sprays directly into the nylon fibre side of the mitt helps too. Follow the dilution guidance below for the correct ratio.

Scrub Away

Using gentle but firm pressure, scrub the surface in circular and up-and-down motions. Working in both directions helps release stubborn dirt from fibrous surfaces like carpet mats or upholstered seats. The bristle-like fibres loosen and lift dirt, grime and stains without damaging delicate surfaces.

Wipe Clean

Once the surface is thoroughly scrubbed, flip the mitt to the soft microfibre side. Use this to remove excess cleaner and dirt residue, leaving a clean, refreshed surface. If you're working a larger area, a separate general purpose microfibre cloth may be needed to lift the excess product.

Repeat as Needed

Repeat the process for stubborn stains or heavily soiled areas until you're happy with the result. The mitt's compact size lets you navigate tight spaces, so you can reach every nook and cranny of the interior.

Rinse and Dry

After cleaning, rinse the mitt with soapy water to remove any remaining cleaner and dirt. Squeeze out the excess water and let it air dry completely before storing it in the included zip bag.

Admire the Results

Stand back and admire your handiwork. The mitt's scrubbing power and precise control leave your interior looking fresh and clean.

Prepare Your Equipment

Gather the Logic All Purpose Interior Cleaner and the Professional Dilution Spray Bottle.

Determine Your Dilution Ratio

Read the Logic label to work out the strength you need. For heavy cleaning we recommend 1:5, and for lighter cleaning 1:10. The graphic below shows how much Logic is needed to make up 947ml in the Professional Dilution Spray Bottle.

Fill the Dilution Bottle

Remove the sprayer from the bottle. Check the marked dilution ratios on the back, fill Logic up to your chosen ratio, then top up with water to the fill ring around the neck.

Mix Thoroughly

Once the Logic and water are in, reattach the sprayer and tighten it.

Use as Directed

Spray the solution onto the surface to be cleaned and work it in with the Finger Scrub Mitt.

After use, store the dilution bottle somewhere cool and dry, away from direct sunlight, with the cap tightened to prevent evaporation or leakage. That keeps the solution usable for next time.