Iron Fallout Remover
Why Use an Iron Fallout Remover?
Run your hand over freshly washed paint and it can still feel rough. Much of that is iron: hot particles from brake dust, railways and industrial fallout that embed in the paint and in the lacquer on your wheels. Shampoo will not shift them, and left alone they show up as tiny orange specks, especially on lighter colours.
An iron fallout remover reacts with those particles and breaks them down chemically so they rinse away. That reaction is what turns it purple. Doing this before you clay means the clay bar has far less to pick up and less to drag across the paint.
How to use Toxin. Wash and rinse the car first, ideally in the shade. Spray Toxin over the paint, wheels and glass and let it dwell until the purple reaction finishes. Agitate heavily contaminated wheels with a wheel brush, then rinse thoroughly. Do not let it dry on the surface.
Iron Fallout Remover FAQs
Everything you need to know about iron fallout removal.
What does an iron fallout remover do?
It chemically breaks down iron particles bonded to your paintwork, wheels and glass so they can be rinsed away. These particles mainly come from brake dust, rail dust and general road contamination, and normal washing will not remove them.
Why does iron fallout remover turn purple?
The purple colour is the active ingredient reacting with iron. The more iron on the surface, the stronger the colour change, so it doubles as a visual check of how contaminated the car is. Once the purple stops developing, the reaction is done and it is time to rinse.
Is using an iron fallout remover necessary?
Not every wash. It is needed when you are decontaminating the paint, before polishing, or before applying a sealant, wax or ceramic coating, so the protection bonds to clean paint. It is also the most effective way to deep clean wheels caked in brake dust.
How often should you use an iron fallout remover?
It depends on how the car is used. Daily drivers, cars with heavy brake dust and cars parked near railways or industrial areas pick up iron faster. Most people decontaminate the paint every few months and do the wheels more often.
Should I use iron fallout remover before or after a clay bar?
Before. Use the fallout remover first to dissolve iron chemically, then a tar remover, then a clay bar to lift anything still bonded. The clay has less to remove, so it lasts longer and is gentler on the paint.
Is iron fallout remover safe on wheels and glass?
Toxin is safe on all exterior surfaces, including paint, wheels, glass and rubber seals. Use it out of direct sunlight and rinse it off before it dries.
Can iron contamination damage paintwork?
Left for long periods, embedded iron can corrode in place, leaving orange spots and a rough surface that dulls the finish. Removing it regularly keeps the paint smooth and gives your protection a clean surface to bond to.
A cleaner surface starts with proper decontamination.
Iron removal is step one. Follow it with a tar remover for sticky road tar, a clay bar for anything still bonded, and a panel wipe to leave the paint completely clean before you apply a sealant or wax.
Browse the full decontamination range to build your routine.


